Installation guide

7-4
System Management
TX Rate: Transmission rate for outgoing data. The unit is
characters per second (cps).
RX Pkts: Total number of received IP packets received during
this connection session.
RX Rate: Reception rate for ingoing data. The unit is characters
per second (cps).
Up Time: Connection time. The format is HH:MM:SS where
HH means hours, MM means minutes, and SS means seconds.
Drop B1: Click to disconnect the B1 channel.
Drop B2: Click to disconnect the B2 channel.
Ethernet LAN Status:
IP Address: IP address of the LAN interface.
TX Packets: Total number of transmitted IP packets send since
the router was powered on.
RX Packets: Total number of transmitted IP packets received
since the router was powered on.
Ethernet WAN Status:
Mode: Indicates which broadband access mode is active.
Depending upon the broadband access mode, you may see
Static IP, PPTP, or PPPoE.
GW IP Address: Indicates the gateway IP address.
IP Address: The 2nd IP Address of Ethernet or the IP address
of WAN interface that is from PPTP/PPPoE connection.
TX Packets: Total number of transmitted IP packets sent during
this connection session.
TX Rate: Transmission rate for outgoing data. The unit is
characters per second (cps).
RX Packets: Total number of transmitted IP packets received
during this connection session.