Installation guide

VigorAccess Installation Guide
11
2
2
.
.
3
3
P
P
a
a
n
n
e
e
l
l
o
o
f
f
M
M
a
a
s
s
t
t
e
e
r
r
D
D
e
e
v
v
i
i
c
c
e
e
All connections are made on the front panel of the VigorAccess (master device) except
power connector.
2
2
.
.
3
3
.
.
1
1
M
M
a
a
s
s
t
t
e
e
r
r
C
C
o
o
n
n
n
n
e
e
c
c
t
t
o
o
r
r
The connections on the front panel of the VigorAccess (master device) are shown below:
Interface Description
Factory Reset
A reset button is used to reset system, and then IPDSLAM will
operate by default configuration.
ACO
Push Bottom for reset alarm
ALARM
RELAY
An alarm relay with RJ45 interface can connect to buzzer when the
FAN is out of order.
CONSOLE
A RS232 serial interface is used to connect a local management
computer.
MGN
A management interface with RJ45 interface is for Telnet or
SNMP management.
UPLINK
The uplink interface with SC connector should be long haul or
short haul Gigabits optical connection.
G1 – G6
The subtend interface with RJ45 interface is Gigabit Ethernet
connection; There are six interfaces to subtend six slaves to expend
DSL capacity.
PHONE
Connected to PSTN normally.
LINE
Connected to twist pair of subscriber line which connects ADSL
devices or telephones for users.
Warning:
z The laser energy of the fiber optic communication channels in the single-mode
will be harmful when operate, especially to the eyes. During normal operation
with cable connection, this energy is confined to the cable with no danger
present.
z Always keep the protective cap on the optic connector while not connected
with cable.
z Never stare into an optical cable or connector when the connector is not in
use.