Operation Manual

VigorNIC 132 Series User’s Guide
51
priority for such VLAN. The range is from 0 to 7.
Open WAN Interface for
this Channel
Check the box to enable relating function.
WAN Application –
 Management – It can be specified for general
management (Web configuration/telnet/TR069). If you
choose Management, the configuration for this VLAN
will be effective for Web configuration/telnet/TR069.
 IPTV - The IPTV configuration will allow the WAN
interface to send IGMP packets to IPTV servers.
WAN Setup –
It is available only when VDSL or Ethernet (WAN2) is
selected as WAN Type. Choose PPPoE/PPPoA Client or
Static or Dynamic IP as the WAN mode for such channel.
 If PPPoE/PPPoA Client is selected as WAN Setup, you
have to configure the settings listed under ISP Access
Setup. Enter your allocated username, password and
authentication parameters according to the information
provided by your ISP.
ISP Name – Type in the name of your ISP.
Username – Type in the username provided by ISP in this
field. The maximum length of the name you can set is 80
characters.
Password – Type in the password provided by ISP in this
field. The maximum length of the password you can set is
48 characters.
PPP Authentication – Select PAP only or PAP or CHAP for
PPP.
 Always On – Check it to keep the network
connection always.
 Idle Timeout – Set the timeout for breaking down
the Internet after passing through the time without
any action.
Fixed IP – Click Yes to use this function and type in a
fixed IP address in the box of Fixed IP Address.
 If Static or Dynamic IP is selected as WAN Setup, you
have to configure the settings listed under WAN IP
Network Settings.
Obtain an IP address automatically – Click this button to
obtain the IP address automatically.
 Router Name – Type in the router name provided by
ISP.
 Domain Name – Type in the domain name that you
have assigned.
Specify an IP address – Click this radio button to specify
some data.
 IP Address – Type in the private IP address.
 Subnet Mask – Type in the subnet mask.
 Gateway IP Address – Type in gateway IP address.
DNS Server IP Address - Type in the primary IP address for
the router if you want to use Static IP mode. If necessary,
type in secondary IP address for necessity in the future.
After finished the above settings, click OK to save the settings and return to previous page.