User`s guide

VigorAP 800 User’s Guide
20
IP Address Type in private IP address for connecting to a local private network
(Default: 192.168.1.2).
Subnet Mask Type in an address code that determines the size of the network.
(Default: 255.255.255.0/ 24)
DHCP Server
Configuration
DHCP stands for Dynamic Host Configuration Protocol. DHCP
server can automatically dispatch related IP settings to any local
user configured as a DHCP client.
Enable Server /
Disable Server
Enable Server lets the modem assign IP address to every host in
the LAN.
Disable Server lets you manually or use other DHCP server to
assign IP address to every host in the LAN.
Start IP Address -
Enter a value of the IP address pool for the DHCP server to start
with when issuing IP addresses. If the 1st IP address of your
modem is 192.168.1.2, the starting IP address must be
192.168.1.3 or greater, but smaller than 192.168.1.254.
End IP Address
Enter a value of the IP address pool for the DHCP server to end
with when issuing IP addresses.
Subnet Mask
Type in an address code that determines the size of the network.
(Default: 255.255.255.0/ 24)
Default Gateway
Enter a value of the gateway IP address for the DHCP server.
Lease Time
It allows you to set the leased time for the specified PC.
Primary IP Address
You must specify a DNS server IP address here because your ISP
should provide you with usually more than one DNS Server. If
your ISP does not provide it, the modem will automatically apply