Operation Manual

VigorBX 2000 Series User’s Guide
7
9
 Password: Type a password. The maximum length
of the password you can set is 62 characters.
Specify an IP address – Click this radio button to specify
some data if you want to use Static IP mode.
 IP Address: Type the IP address.
 Subnet Mask: Type the subnet mask.
 Gateway IP Address: Type the gateway IP
address.
Default MAC Address: Click this radio button to use default
MAC address for the router.
Specify a MAC Address: Some Cable service providers
specify a specific MAC address for access authentication. In
such cases you need to click the Specify a MAC Address and
enter the MAC address in the MAC Address field.
DNS Server IP Address Type in the primary IP address for the router if you want to
use Static IP mode. If necessary, type in secondary IP address
for necessity in the future.
After finishing all the settings here, please click OK to activate them.
I
I
I
I
-
-
1
1
-
-
2
2
-
-
7
7
D
D
e
e
t
t
a
a
i
i
l
l
s
s
P
P
a
a
g
g
e
e
f
f
o
o
r
r
P
P
P
P
T
T
P
P
/
/
L
L
2
2
T
T
P
P
i
i
n
n
W
W
A
A
N
N
2
2
To use PPTP/L2TP as the accessing protocol of the internet, please click the PPTP/L2TP tab.
The following web page will be shown.
Available settings are explained as follows:
Item Description
PPTP/L2TP Enable PPTP- Click this radio button to enable a PPTP client
to establish a tunnel to a DSL modem on the WAN interface.
Enable L2TP - Click this radio button to enable a L2TP client
to establish a tunnel to a DSL modem on the WAN interface.
Disable – Click this radio button to close the connection
through PPTP or L2TP.
Server Address - Specify the IP address of the PPTP/L2TP
server if you enable PPTP/L2TP client mode.
Specify Gateway IP Address – Specify the gateway IP address