Operation Manual

VigorBX 2000 Series User’s Guide
760
value It means the number to be tagged on packets.
The range of the value is between 32 ~ 4095.
enable|disable It means to enable or disable the WAN interface for VLAN.
stat It means to display the table of WAN VLAN status.
E
E
x
x
a
a
m
m
p
p
l
l
e
e
> wan vlan stat
%Interface Pri Tag Enabled
%======================================
% WAN1 (ADSL) 0 0
% WAN1 (VDSL) 0 0
%WAN2 0 0
T
T
e
e
l
l
n
n
e
e
t
t
C
C
o
o
m
m
m
m
a
a
n
n
d
d
:
:
w
w
o
o
l
l
This command allows Administrator to set the white list of WAN IP addresses/Subnets, that
the magic packet from these IP addresses/Subnets will be eligible to pass through NAT and
wake up the LAN client. You also need to set NAT rule for LAN client.
wol up [MAC Address]/[IP Address]
wol fromWan [on/off/any]
wol fromWan_Setting [idx][ip address][mask]
S
S
y
y
n
n
t
t
a
a
x
x
D
D
e
e
s
s
c
c
r
r
i
i
p
p
t
t
i
i
o
o
n
n
Parameter Description
MAC Address It means the MAC address of the host.
IP address It means the LAN IP address of the host. If you want to wake up LAN
host by using IP address, be sure that that IP address has been
bound with the MAC address (IP BindMAC).
on/off/any It means to enable or disable the function of WOL from WAN.
on: enable
off: disable
any: It means any source IP address can pass through NAT and wake
up the LAN client.
This command will allow the user to choose whether WoL packets
can be passed from the Internet to the LAN network from a specific
WAN interface.
[idx][ip address] [mask] It means the index number (from 1 to 4).
These commands will allow the user to configure the LAN clients
that the user may wake up from the Internet through the use of the
WoL packet.
ip address - It means the WAN IP address.
mask - It means the mask of the IP address.