Operation Manual
VigorBX 2000 Series User’s Guide
74
7
Actual Data Rate: 0 0 Kb/s
SNR: 0 0 0.1dB
> wan vdsl fbk_mode vdsl_only
Set VDSL fallback mode to VDSL ONLY
Reboot system to take effect
>
T
T
e
e
l
l
n
n
e
e
t
t
C
C
o
o
m
m
m
m
a
a
n
n
d
d
:
:
w
w
a
a
n
n
d
d
e
e
t
t
e
e
c
c
t
t
This command allows you to Ping a specified IP to detect the WAN connection (static IP or
PPPoE mode).
wan detect [wan1][on/off/always_on]
wan detect [wan1]target [ip addr]
wan detect [wan1]ttl [1-255]
wan detect status
S
S
y
y
n
n
t
t
a
a
x
x
D
D
e
e
s
s
c
c
r
r
i
i
p
p
t
t
i
i
o
o
n
n
Parameter Description
on It means to enable ping detection. The IP address of the target shall
be set.
off It means to enable ARP detection (default).
always_on disable link detect, always connected(only support static IP)
target It means to set the ping target.
ip addr It means the IP address used for detection. Type an IP address in this
field.
ttl It means to set the ping TTL value (work as trace route)
If you do not set any value for ttl here or just type 0 here, the
system will use default setting (255) as the ttl value.
status It means to show the current status.
E
E
x
x
a
a
m
m
p
p
l
l
e
e
> wan detect status
WAN1: always on
WAN2: off
WAN3: off
WAN4: off
WAN5: off
> wan detect wan1 target 192.168.1.78
Set OK
> wan detect wan1 on
Set OK
> wan detect status
WAN1: on, Target=192.168.1.78, TTL=255
WAN2: off
WAN3: off