Operation Manual

VigorBX 2000 Series User’s Guide
70
9
on It means to enable IPSec ESP tunnel passthrough and IKE source port
(500) preservation.
off It means to disable IPSec ESP tunnel passthrough and IKE source
port (500) preservation.
status It means to display current status for checking.
E
E
x
x
a
a
m
m
p
p
l
l
e
e
> srv nat ipsecpass status
%% Status: IPsec ESP pass-thru and IKE src_port:500 preservation is OFF.
T
T
e
e
l
l
n
n
e
e
t
t
C
C
o
o
m
m
m
m
a
a
n
n
d
d
:
:
s
s
r
r
v
v
n
n
a
a
t
t
o
o
p
p
e
e
n
n
p
p
o
o
r
r
t
t
This command allows users to set open port settings for NAT server.
srv nat openport n m [-<command> <parameter> | … ]
S
S
y
y
n
n
t
t
a
a
x
x
D
D
e
e
s
s
c
c
r
r
i
i
p
p
t
t
i
i
o
o
n
n
Parameter Description
n It means the index number for the profiles. The range is from 1 to
20.
m It means to specify the sub-item number for this profile. The range
is from 1 to 10.
[<command>
<parameter>|…]
The available commands with parameters are listed below.
[…] means that you can type in several commands in one line.
-a <enable> It means to enable or disable the open port rule profile.
0: disable
1:enable
-c <comment> It means to type the description (less than 23 characters) for the
defined network service.
-i <local ip> It means to set the IP address for local computer.
Local ip: Type an IP address in this field.
-w <idx> It means to specify the public IP.
1: WAN1 Default,
2: WAN1 Alias 1,
…and so on.
-p <protocol> Specify the transport layer protocol.
Available values are TCP, UDP and ALL.
-s<start port> It means to specify the starting port number of the service offered
by the local host. The range is from 0 to 65535.
-e<end port> It means to specify the ending port number of the service offered by