Operation Manual

VigorBX 2000 Series User’s Guide
284
receive. This function is very useful when the network
traffic congestion occurs and it still can remain the
accuracy of DTMF tone.
 SIP INFO- Choose this one then the Vigor will capture
the DTMF tone and transfer it into SIP form. Then it will
be sent to the remote end with SIP message.
Payload Type (rfc2833) - Type a number from 96 to 127, the
default value was 101. This setting is available for the
OutBand (RFC2833) mode.
Replace + digit in caller ID to - For international phone call,
the phone number could add a '+' sign, for example,
[phone]. However, the caller ID (DTMF type especially)
can not display '+' at all.
Therefore, this function can be enabled to give another
number to replace the plus sign, for example, “+” can be
replaced by “00”. Then the above phone number will
become 008865972727. When the callee receives such
number, he can use re-dial function to dial back to the
caller.
After finishing all the settings here, please click OK to save the configuration.