Operation Manual

VigorBX 2000 Series User’s Guide
283
tone, ringing tone, busy tone, congestion tone by yourself for
VoIP phone.
Also, you can specify each field for your necessity. It is
recommended for you to use the default settings for VoIP
communication.
Volume Gain Mic Gain (1-10)/Speaker Gain (1-10) - Adjust the volume of
microphone and speaker by entering number from 1- 10. The
larger of the number, the louder the volume is.
MISC Dial Tone Power Level - This setting is used to adjust the
loudness of the dial tone. The smaller the number is, the
louder the dial tone is. It is recommended for you to use the
default setting.
Ring Frequency - This setting is used to drive the frequency
of the ring tone. It is recommended for you to use the
default setting.
Call Waiting Tone Power Level - This setting is used to
adjust the loudness of the call waiting tone. The smaller the
number is, the louder the tone is. It is recommended for you
to use the default setting.
DTMF DTMF Mode – There are four DTMF modes for you to choose.
 InBand - Choose this one then the Vigor will send the
DTMF tone as audio directly when you press the keypad
on the phone.
 OutBand - Choose this one then the Vigor will capture
the keypad number you pressed and transform it to
digital form then send to the other side; the receiver
will generate the tone according to the digital form it