Operation Manual

VigorAP 920R Series User’s Guide

please select AutoSelect to let system determine for you.

Extension Channel

With 802.11n, there is one option to double the bandwidth per

channel. The available extension channel options will be varied

according to the Channel selected above. Configure the

extension channel you want.

Rate

If 11b Only is selected as Mode, such feature will be available

to set data transmission rate.

Enable

Check the box to enable the SSID configuration.

Hide SSID

Check it to prevent from wireless sniffing and make it harder

for unauthorized clients or STAs to join your wireless LAN.

Depending on the wireless utility, the user may only see the

information except SSID or just cannot see any thing about

VigorAP 920RP while site surveying. The system allows you

to set four sets of SSID for different usage.

SSID

Set a name for VigorAP 920RP to be identified. Default setting

is DrayTek.

Isolate LAN

Check this box to make the wireless clients (stations) with the

same SSID not accessing for wired PC in LAN.

Isolate Member

Check this box to make the wireless clients (stations) with the

same SSID not accessing for each other.

VLAN ID

Type the value for such SSID. Packets transferred from such

SSID to LAN will be tagged with the number.

If your network uses VLANs, you can assign the SSID to a

VLAN on your network. Client devices that associate using the

SSID are grouped into this VLAN. The VLAN ID range is

from 3 to 4095. The VLAN ID is 0 by default, it means

disabling the VLAN function for the SSID.

PHY Mode

Data will be transmitted via HTMIX mode.

Each access point should be setup to the same PHY Mode for

connecting with each other.

Security

Select Disabled, TKIP or AES as the encryption algorithm.

Peer MAC Address

Four peer MAC addresses are allowed to be entered in this

page at one time.

After finishing this web page configuration, please click OK to save the settings.