Operation Manual

VigorAP 920R Series User’s Guide
34
Configuration
will be treated as a client and can be managed / controlled by AP
Management server offered by Vigor router (e.g., Vigor2860).
IP Address – Type in private IP address for connecting to a local
private network (Default: 192.168.1.2).
Subnet Mask – Type in an address code that determines the size
of the network. (Default: 255.255.255.0/ 24)
Enable Management VLAN – VigorAP 920RP supports
tag-based VLAN for wireless clients accessing Vigor device.
Only the clients with the specified VLAN ID can access into
VigorAP 920RP.
VLAN ID – Type the number as VLAN ID tagged on the
transmitted packet. “0” means no VALN tag.
DHCP Server
Configuration
DHCP stands for Dynamic Host Configuration Protocol. DHCP
server can automatically dispatch related IP settings to any local
user configured as a DHCP client.
Enable Server - Enable Server lets the modem assign IP address
to every host in the LAN.
 Start IP Address - Enter a value of the IP address pool for
the DHCP server to start with when issuing IP addresses. If
the 1st IP address of your modem is 192.168.1.2, the
starting IP address must be 192.168.1.3 or greater, but
smaller than 192.168.1.254.
 End IP Address - Enter a value of the IP address pool for
the DHCP server to end with when issuing IP addresses.
 Subnet Mask - Type in an address code that determines
the size of the network. (Default: 255.255.255.0/ 24)
 Default Gateway - Enter a value of the gateway IP address
for the DHCP server.
 Lease Time - It allows you to set the leased time for the
specified PC.
 Primary DNS Server - You must specify a DNS server IP
address here because your ISP should provide you with
usually more than one DNS Server. If your ISP does not
provide it, the modem will automatically apply default
DNS Server IP address: 194.109.6.66 to this field.
 Secondary DNS Server - You can specify secondary DNS
server IP address here because your ISP often provides you
more than one DNS Server. If your ISP does not provide it,
the modem will automatically apply default secondary
DNS Server IP address: 194.98.0.1 to this field.
Relay Agent - Specify which subnet that DHCP server is located
the relay agent should redirect the DHCP request to.
 DHCP Server IP Address for Relay Agent - It is available
when Enable Relay Agent is selected. Set the IP address of
the DHCP server you are going to use so the Relay Agent
can help to forward the DHCP request to the DHCP server.