Operation Manual

VigorAP 920R Series User’s Guide
138
Cancel
Give up the access control set up.
Backup
Click it to store the settings (MAC addresses on MAC Address
Filter table) on this page as a file.
Restore
Click it to restore the settings (MAC addresses on MAC
Address Filter table) from an existed file.
After finishing this web page configuration, please click OK to save the settings.
3
3
.
.
9
9
.
.
4
4
W
W
P
P
S
S
Open Wireless LAN>>WPS to configure the corresponding settings.
Available settings are explained as follows:
Item Description
Enable WPS
Check this box to enable WPS setting.
WPS Configured
Display related system information for WPS. If the wireless
security (encryption) function of VigorAP 920RP is properly
configured, you can see ‘Yes’ message here.
WPS SSID
Display current selected SSID.
WPS Auth Mode
Display current authentication mode of the VigorAP 920RP.
Only WPA2/PSK and WPA/PSK support WPS.
WPS Encryp Type
Display encryption mode (None, WEP, TKIP, AES, etc.) of
VigorAP 920RP.
Configure via Push
Button
Click Start PBC to invoke Push-Button style WPS setup
procedure. VigorAP 920RP will wait for WPS requests from
wireless clients about two minutes. Both ACT and 5G WLAN
LEDs on VigorAP 920RP will blink quickly when WPS is in
progress. It will return to normal condition after two minutes.
(You need to setup WPS within two minutes)
Configure via Client
PinCode
Type the PIN code specified in wireless client you wish to
connect, and click Start PIN button. Both ACT and 5G