Operation Manual

VigorAP 920R Series User’s Guide
133
can set is from 3 to 128.
Enable Limit Client
per SSID
Define the maximum number of wireless stations per SSID
which try to connect to Internet through Vigor device. The
number you can set is from 3 to 128.
Mode
At present, VigorAP 920RP can be connected by 11a only, 11n
only (5G), Mixed (11a+11n) and Mixed (11a+11n+ac) stations
simultaneously. Simply choose Mixed (11a+11n+ac) mode.
Channel
Means the channel of frequency of the wireless LAN. The
default channel is AutoSelect. You may switch channel if the
selected channel is under serious interference.
Filtered Out List
Such link will be shown if AutoSelect is selected as Channel.
Click such link to access into Wireless LAN >> Advanced
Settings page.
Hide SSID
Check it to prevent from wireless sniffing and make it harder for
unauthorized clients or STAs to join your wireless LAN.
Depending on the wireless utility, the user may only see the
information except SSID or just cannot see any thing about
VigorAP 920RP while site surveying. The system allows you to
set four sets of SSID for different usage.
SSID
Set a name for VigorAP 920RP to be identified. Default settings
are DrayTek5G.
Isolate Member
Check this box to make the wireless clients (stations) with the
same SSID not accessing for each other.
VLAN ID
Type the value for such SSID. Packets transferred from such
SSID to LAN will be tagged with the number.
If your network uses VLANs, you can assign the SSID to a
VLAN on your network. Client devices that associate using the
SSID are grouped into this VLAN. The VLAN ID range is from
3 to 4095. The VLAN ID is 0 by default, it means disabling the
VLAN function for the SSID.
After finishing this web page configuration, please click OK to save the settings.