Operation Manual

VigorAP 910C User’s Guide
229
AP last time.
CPE Settings
Such information is useful for Auto Configuration Server (ACS).
Enable– Check the box to allow the CPE Client to connect with
Auto Configuration Server.
SSL(HTTPS) Mode - Check the box to allow the CPE client to
connect with ACS through SSL.
Port – Sometimes, port conflict might be occurred. To solve
such problem, you might change port number for CPE.
Username/Password – Type the username and password that
VigorACS can use to access into such CPE.
Periodic Inform
Settings
The default setting is Enable. Please set interval time or
schedule time for the AP to send notification to VigorACS
server. Or click Disable to close the mechanism of notification.
Interval Time – Type the value for the interval time setting. The
unit is “second”.
STUN Settings
The default is Disable. If you click Enable, please type the
relational settings listed below:
Server Address – Type the IP address of the STUN server.
Server Port – Type the port number of the STUN server.
Minimum Keep Alive Period – If STUN is enabled, the CPE
must send binding request to the server for the purpose of
maintaining the binding in the Gateway. Please type a number as
the minimum period. The default setting is “60 seconds”.
Maximum Keep Alive Period – If STUN is enabled, the CPE
must send binding request to the server for the purpose of
maintaining the binding in the Gateway. Please type a number as
the maximum period. A value of “-1” indicates that no
maximum period is specified.
After finishing this web page configuration, please click OK to save the settings.