Operation Manual

VigorAP 910C User’s Guide
160
Country Code
VigorAP broadcasts country codes by following the 802.11d
standard. However, some wireless stations will detect / scan
the country code to prevent conflict occurred. If conflict is
detected, wireless station will be warned and is unable to make
network connection. Therefore, changing the country code to
ensure successful network connection will be necessary for
some clients.
Auto Channel
Reselect
Enable – Usually, wireless channel determined by AutoSelect
(Wireless LAN>>General Setup) means Vigor router will
search for a channel with low interference automatically once
the system reboots. However, when the channel utilization is
more than 70% (refer to Diagnostics >> Interference
Monitor), Vigor router will search for and switch another
channel with low interference to obtain better wireless signal
again.
Auto Channel
Filtered Out List
The selected wireless channels will be discarded if AutoSelect
is selected as Channel selection mode in Wireless
LAN>>General Setup.
Isolate 2.4GHz and
5GHz bands
The default setting is “Enable”. It means that the wireless
client using 2.4GHz band is unable to connect to the wireless
client with 5GHz band, and vice versa.
For WLAN 2.4GHz and 5GHz set with the same SSID name:
 No matter such function is enabled or disabled, clients
using WLAN 2.4GHz and 5GHz can communicate for
each other if Isolate Member (in Wireless
LAN>>General Setup) is NOT enabled for such SSID.
 Yet, if the function of Isolate Member (in Wireless
LAN>>General Setup) is enabled for such SSID, clients
using WLAN 2.4GHz and 5GHz will be unable to
communicate with each other.
Isolate members with
IP
The default setting is “Disable”.
If it is enabled, VigorAP will isolate different wireless clients
according to their IP address(es).