Operation Manual

99
III-1-9 Management
This page allows you to specify the port number for HTTP and HTTPS server.
Available parameters are explained as follows:
Item Description
Device Name The default setting is VigorAP 903. Change the name if required.
Access Control Allow management from WLAN - Enable the checkbox to allow system
administrators to login from wireless LAN.
Enable Telnet Server– The administrator / user can access into the
command line interface of VigorAP remotely for configuring settings.
Access List Enable access list – Check the box to specify that the system
administrator can only login from a specific host or network defined in the
list. A maximum of five IPs/subnet masks is allowed.
Port Setup HTTP port/HTTPS port -Specify user-defined port numbers for the HTTP
and HTTPS servers.
Panel Control
Disable WLAN button - The default function of WLAN button is enabled.
To disable the ability of the Wireless button to control WLAN and WPS
functions, check this box. Disabling the wireless button only prevents it
from being used to control WLAN functions.
Disable LED - The LEDs blink always since VigorAP is powered on. Some
people might not like that. Therefore the function of LED is allowed to be
disabled to make people feeling comfortable and undisturbed. After
checking it, all the LEDs on VigorAP will light off immediately after clicking
OK.