Operation Manual

VigorAP 902 User’s Guide
236
modem.
3. Click Restore button and wait for few seconds, the following picture will tell you that
the restoration procedure is successful.
3
3
.
.
1
1
6
6
.
.
5
5
S
S
y
y
s
s
l
l
o
o
g
g
/
/
M
M
a
a
i
i
l
l
A
A
l
l
e
e
r
r
t
t
SysLog function is provided for users to monitor AP. There is no bother to directly get into
the Web user interface of the AP or borrow debug equipments.
Available settings are explained as follows:
Item Description
Syslog Access Setup
Enable - Check Enable to activate function of Syslog.
Server IP Address -The IP address of the Syslog server.
Destination Port -Assign a port for the Syslog protocol. The
default setting is 514.
Log Level - Specify which level of the severity of the event will
be recorded by Syslog.
Mail Alert Setup
Check Enable to activate function of mail alert.
SMTP Server - The IP address of the SMTP server.
Mail To - Assign a mail address for sending mails out.
Mail From - Assign a path for receiving the mail from outside.
User Name - Type the user name for authentication.
Password - Type the password for authentication.
Use TLS – Check this box to encrypt alert mail. However, if the
SMTP server specified here does not support TLS protocol, the
alert mail with encrypted data will not be received by the
receiver.
Enable E-Mail Alert - VigorAP will send an e-mail out when a
user accesses into the user interface by using web or telnet.