Operation Manual

VigorAP 902 User’s Guide
165
Display All Station
Control List
All the wireless stations connecting to Vigor router by using
such SSID will be listed on Station Control List.
After finishing all the settings here, please click OK to save the configuration.
3
3
.
.
1
1
0
0
.
.
1
1
1
1
R
R
o
o
a
a
m
m
i
i
n
n
g
g
The network signal for a single wireless access point might be limited by its coverage range.
Therefore, if you want to expand the wireless network in a large exhibition with a quick
method, you can install multiple access points with enabling the Roaming feature for each
AP to reach the purpose of expanding wireless signals seamlessly.
These access points connecting for each other shall be verified by pre-authentication. This
page allows you to enable the roaming feature and the pre-authentication.
Available settings are explained as follows:
Item Description
AP-assisted Client
Roaming Parameters
When the link rate of wireless station is too low or the signal
received by the wireless station is too worse, VigorAP 902 will
automatically detect (based on the link rate and RSSI
requirement) and cut off the network connection for that wireless
station to assist it to connect another Wireless AP to get better
signal.
Minimum Basic Rate – Check the box to use the drop down list
to specify a basic rate (Mbps). When the link rate of the wireless