Operation Manual

VigorAP 810 User’s Guide
74
the same manner as broadcast traffic.
Isolate members with
IP
The default setting is “Disable”.
If it is enabled, VigorAP will isolate different wireless clients
according to their IP address(es).
MAC Clone
Click Enable and manually enter the MAC address of the
device with SSID 1. The MAC address of other SSIDs will
change based on this MAC address.
3
3
.
.
7
7
.
.
3
3
A
A
P
P
D
D
i
i
s
s
c
c
o
o
v
v
e
e
r
r
y
y
VigorAP 810 can scan all regulatory channels and find working APs in the neighborhood.
Based on the scanning result, users will know which channel is clean for usage. Also, it can
be used to facilitate finding an AP for a WDS link. Notice that during the scanning process
(about 5 seconds), no client is allowed to connect to VigorAP 810.
This page is used to scan the existence of the APs on the wireless LAN. Yet, only the AP
which is in the same channel of VigorAP 810 can be found. Please click Scan to discover all
the connected APs.
Available settings are explained as follows:
Item Description
Enable AP Monitor
Mode
This function can help to get and keep the records of APs
detected by such device after clicking Scan.
In general, only the available AP will be detected by Vigor
device. Once the AP is unavailable, it will be deleted from the
Access Point List immediately. However, if such function is
enabled, the system will keep the record of the AP (once
detected by Vigor device) until it is available for Vigor device
again.
SSID
Display the SSID of the AP scanned by VigorAP 810.
BSSID
Display the MAC address of the AP scanned by VigorAP 810.