Operation Manual

VigorAP 810 User’s Guide
30
Default Gateway – In general, it is not really necessary to
specify a gateway for VigorAP. However, if it is required, simply
type an IP address as the gateway for VigorAP. It will be
convenient for the access point to acquire more service (e.g.,
accessing NTP server) from Vigor router.
Enable Management VLAN – VigorAP supports tag-based
VLAN for wireless clients accessing Vigor device. Only the
clients with the specified VLAN ID can access into VigorAP.
VLAN ID – Type the number as VLAN ID tagged on the
transmitted packet. “0” means no VALN tag.
LAN-B IP Network
Configuration
Enable DHCP Client – When it is enabled, VigorAP will be
treated as a client and can be managed / controlled by AP
Management server offered by Vigor router (e.g., Vigor2860).
IP Address – Type in private IP address for connecting to a local
private network (Default: 192.168.2.2).
Subnet Mask – Type in an address code that determines the size
of the network. (Default: 255.255.255.0/ 24)
Enable Management VLAN – VigorAP 902 supports tag-based
VLAN for wireless clients accessing Vigor device. Only the
clients with the specified VLAN ID can access into VigorAP.
VLAN ID – Type the number as VLAN ID tagged on the
transmitted packet. “0” means no VALN tag.
DHCP Server
Configuration
DHCP stands for Dynamic Host Configuration Protocol. DHCP
server can automatically dispatch related IP settings to any local
user configured as a DHCP client.
Enable Server - Enable Server lets the modem assign IP address
to every host in the LAN.
 Start IP Address - Enter a value of the IP address pool for
the DHCP server to start with when issuing IP addresses. If
the 1st IP address of your modem is 192.168.1.2, the
starting IP address must be 192.168.1.3 or greater, but
smaller than 192.168.1.254.
 End IP Address - Enter a value of the IP address pool for
the DHCP server to end with when issuing IP addresses.
 Subnet Mask - Type in an address code that determines
the size of the network. (Default: 255.255.255.0/ 24)
 Default Gateway - Enter a value of the gateway IP address
for the DHCP server.
 Lease Time - It allows you to set the leased time for the
specified PC.
 Primary DNS Server - You must specify a DNS server IP
address here because your ISP should provide you with
usually more than one DNS Server. If your ISP does not
provide it, the modem will automatically apply default
DNS Server IP address: 194.109.6.66 to this field.
 Secondary DNS Server - You can specify secondary DNS