Operation Manual

VigorAP 810 User’s Guide
111
Ch. Width
Display the channel width that the scanned AP used.
Scan
It is used to discover all the connected AP. The results will be
shown on the box above this button
Channel Statistics
It displays the statistics for the channels used by APs.
AP’s MAC Address
If you want the found AP applying the WDS settings, please
type in the AP’s MAC address.
AP’s SSID
To specify an AP to be applied with WDS settings, you can
specify MAC address or SSID for the AP. Here is the place that
you can type the SSID of the AP.
Select as Universal
Repeater
In Universal Repeater mode, WAN would work as station
mode and the wireless AP can be selected as a universal
repeater. Choose one of the wireless APs from the Scan list.
After finishing this web page configuration, please click OK to save the settings.
3
3
.
.
9
9
.
.
7
7
U
U
n
n
i
i
v
v
e
e
r
r
s
s
a
a
l
l
R
R
e
e
p
p
e
e
a
a
t
t
e
e
r
r
The access point can act as a wireless repeater; it can be Station and AP at the same time. It
can use Station function to connect to a Root AP and use AP function to serve all wireless
stations within its coverage.
Note: While using Universal Repeater mode, the access point will demodulate the
received signal. Please check if this signal is noise for the operating network, then have
the signal modulated and amplified again. The output power of this mode is the same as
that of WDS and normal AP mode.
Available settings are explained as follows:
Item Description
SSID
Set the name of access point that VigorAP 810 wants to
connect to.
MAC Address
(Optional)
Type the MAC address of access point that VigorAP 810 wants
to connect to.
Channel
Means the channel of frequency of the wireless LAN. The
default channel is 11. You may switch channel if the selected