Operation Manual

VigorAP 710 User’s Guide
90
return to normal condition after two minutes. (You need to
setup WPS within two minutes)
Configure via Client
PinCode
Type the PIN code specified in wireless client you wish to
connect, and click Start PIN button. The WLAN LED on
VigorAP 710 will blink fast when WPS is in progress. It will
return to normal condition after two minutes. (You need to
setup WPS within two minutes).
3
3
.
.
8
8
.
.
5
5
A
A
d
d
v
v
a
a
n
n
c
c
e
e
d
d
S
S
e
e
t
t
t
t
i
i
n
n
g
g
This page is to determine which algorithm will be selected for wireless transmission rate.
Available settings are explained as follows:
Item Description
Channel Width
20 MHz- the device will use 20MHz for data transmission and
receiving between the AP and the stations.
Auto 20/40 MHz– the AP will scan for nearby wireless AP,
and then use 20MHz if the number of AP is more than 10, or
use 40MHz if it's not.
40 MHz- the device will use 40MHz for data transmission and
receiving between the AP and the stations.
Packet-OVERDRIVE
This feature can enhance the performance in data transmission
about 40%* more (by checking Tx Burst). It is active only
when both sides of Access Point and Station (in wireless
client) invoke this function at the same time. That is, the
wireless client must support this feature and invoke the
function, too.
Note: Vigor N61 wireless adapter supports this function.
Therefore, you can use and install it into your PC for matching
with Packet-OVERDRIVE (refer to the following picture of