Operation Manual

VigorAP 710 User’s Guide
23
Note: The Wireless LAN settings will be changed according to the Operation Mode
selected here. For the detailed information, please refer to the section of Wireless LAN.
3
3
.
.
2
2
L
L
A
A
N
N
Local Area Network (LAN) is a group of subnets regulated and ruled by modem.
3
3
.
.
2
2
.
.
1
1
G
G
e
e
n
n
e
e
r
r
a
a
l
l
S
S
e
e
t
t
u
u
p
p
Click LAN to open the LAN settings page and choose General Setup.
Note: Such page will be changed according to the Operation Mode selected. The
following screen is obtained by choosing AP as the operation mode.
Available settings are explained as follows:
Item Description
LAN IP Network
Configuration
Enable DHCP Client – When it is enabled, VigorAP 710 will
be treated as a client and can be managed / controlled by AP
Management server offered by Vigor router (e.g., Vigor2860).
 IP Address – Type in private IP address for connecting to a
local private network (Default: 192.168.1.2).
 Subnet Mask – Type in an address code that determines
the size of the network. (Default: 255.255.255.0/ 24)
 Default Gateway - In general, it is not really necessary to
specify a gateway for VigorAP 710. However, if it is
required, simply type an IP address as the gateway for
VigorAP 710. It will be convenient for the access point
acquiring more service (e.g., accessing NTP server) from
Vigor router.
Enable Management VLAN – VigorAP 710 supports tag-based
VLAN for wireless clients accessing Vigor device. Only the
clients with the specified VLAN ID can access into VigorAP