User`s guide

VigorPro5510 Series User’s Guide
63
Protocol Display the protocol used for this address mapping.
Public IP Display the public IP address selected for this entry, e.g.,
172.16.3.102.
Private IP Display the private IP set for this address mapping, e.g.,
192.168.1.10
Mask Display the subnet mask selected for this address mapping.
Status Display the status for the entry, enable or disable.
Click the index number link to open the configuration page.
Enable Check to enable this entry.
Protocol Specify the transport layer protocol. It could be TCP, UDP, or
ALL for selection.
WAN IP Select an IP address (the selections provided here are set in IP
Alias List of Network >>WAN interface). Local host can use this
IP to connect to Internet.
If you want to choose any one of the Public IP settings, you must
specify some IP addresses in the IP Alias List of the Static/DHCP
Configuration page first. If you did not type in any IP address in