User`s guide

VigorPro5510 Series User’s Guide
130
In the Bandwidth Management menu, click Bandwidth Limit to open the web page.
To activate the function of limit bandwidth, simply click Enable and set the default upstream
and downstream limit.
Enable
Click this button to activate the function of limit bandwidth.
Apply to 2
nd
Subnet – if bandwidth limit function is
enabled, please check this box to apply to second subnet.
Disable
Click this button to close the function of limit bandwidth.
Default TX limit
Define the default speed of the upstream for each computer
in LAN.
Default RX limit
Define the default speed of the downstream for each
computer in LAN.
Allow auto adjustment to
make the best utilization of
available bandwidth
.
Router will detect if there is enough bandwidth remained for
using according to the bandwidth limit set by the user. If yes,
the router will adjust the available bandwidth for users to
enhance the total utilization.
Limitation List
Display a list of specific limitations that you set on this web
page.
Start IP
Define the start IP address for limit bandwidth.
End IP
Define the end IP address for limit bandwidth.
Each/Shared
Select Each to make each IP within the range of Start IP and
End IP having the same speed defined in TX limit and RX
limit fields; select Shared to make all the IPs within the
range of Start IP and End IP share the total bandwidth of TX