Installation guide

106
Configuration:
1. Block LAN-to-LAN communication.
2. Create VLAN5, VLAN6, VLAN7 and VLAN8 Groups.
3. In the VLAN5, input “5” to VLAN ID. In the Member field, choose p1. Then
choose the “Untagged” for Frame Tag Operation in p1. We should configure the
PVID to “5”, because the device does not support 802.1Q VLAN.
4. In the VLAN6, input “6” to VLAN ID. In the Member field, choose p2. Then
choose the “Untagged” for Frame Tag Operation in p2. We should configure the
PVID to “6”, because the device does not support 802.1Q VLAN.
5. In the VLAN7, input “7” to VLAN ID. In the Member field, choose p3. Then
choose the “Untagged” for Frame Tag Operation in p3. We should configure the
PVID to “7”, because the device does not support 802.1Q VLAN.
6. In the VLAN8, input “8” to VLAN ID. In the Member field, choose p4. Then
choose the “Untagged” for Frame Tag Operation in p4. We should configure the
PVID to “8”, because the device does not support 802.1Q VLAN.
7. After applying the settings, the web page will be redirected to “reboot” web page.
User can ignore it and continue to configure the Network setting. After Network
setting, then you can do the reboot procedure.
Note
After rebooting, the tagged ports will only communicate with 802.1Q tagged devices.
Figure 5-7. LAN VLAN configuration
8. In the Network setting, input the subnet 192.168.1.0 to LAN. For example, the
VLAN5 LAN IP is 192.168.1.1 and Subnet Mask is 255.255.255.0. Then, users in
the Engineer Department can set IP address from 192.168.1.2 to 192.168.1.254.