Installation guide

101

Policy 1

For computers (Server) with IP range from 192.168.33.1 to 192.168.33.15, with HTTP

protocol traffics are applied to WAN1 interface.

Policy 2

For computers (Directors) with IP range from 192.168.33.16 to 192.168.33.31, with

HTTP protocol traffics are applied to WAN2 interface.

Policy 3

For computers (MIS) with IP range from 192.168.33.32 to 192.168.33.63, with HTTP

protocol traffics are applied to WAN2 interface.

Policy 4

For other computers with IP range from 192.168.33.0 to 192.168.33.255, with HTTP

traffics are applied to WAN3 interface. (The network set in this policy covers the network

set in Policy1~ Policy3). And the protocol is also the HTTP protocol. However the Load

Balance Policy will compare the traffics with the policy rules item by item from the

smallest index number rule. So although the settings are overlapped, actually these

policies can work normally. For an easy management you may set separate IP range for

each policy.

Policy 5

For all the computers with IP range from 192.168.33.0 to 192.168.33.255, with FTP

protocol traffics are applied to WAN3 interface.

Policy 6

For a computer (Mail Server) with IP address 192.168.33.11, with TCP Port 1~65535 are

applied to WAN1 interface (The Subnet Mask is empty to be equal to 255.255.255.255).

Policy 7

For a computer (Mail Server) with IP range 192.168.33.11, with UDP Port 1~65535 are

applied to WAN1 interface.