User`s guide

Vigor3200 Series User’s Guide
234
Key - Type 8 ~ 63 ASCII characters or 64 hexadecimal digits
leading by “0x”.
Bridge
If you choose Bridge as the connecting mode, please type in the
peer MAC address in these fields. Four peer MAC addresses are
allowed to be entered in this page at one time. Yet please disable
the unused link to get better performance. If you want to invoke
the peer MAC address, remember to check Enable box in the
front of the MAC address after typing.
Repeater
If you choose Repeater as the connecting mode, please type in
the peer MAC address in these fields. Four peer MAC addresses
are allowed to be entered in this page at one time. Similarly, if
you want to invoke the peer MAC address, remember to check
Enable box in the front of the MAC address after typing.
Access Point Function
Click Enable to make this router serving as an access point;
click Disable to cancel this function.
Status
It allows user to send “hello” message to peers. Yet, it is valid
only when the peer also supports this function.
4
4
.
.
1
1
2
2
.
.
7
7
A
A
d
d
v
v
a
a
n
n
c
c
e
e
d
d
S
S
e
e
t
t
t
t
i
i
n
n
g
g
This page allows users to set advanced settings such as operation mode, channel bandwidth,
guard interval, and aggregation MSDU for wireless data transmission.
Operation Mode
Mixed Mode – the router can transmit data with the ways
supported in both 802.11a/b/g and 802.11n standards. However,
the entire wireless transmission will be slowed down if 802.11g
or 802.11b wireless client is connected.
Green Field – to get the highest throughput, please choose such
mode. Such mode can make the data transmission happening
between 11n systems only. In addition, it does not have
protection mechanism to avoid the conflict with neighboring
devices of 802.11a/b/g.
Channel Bandwidth
20- the router will use 20Mhz for data transmission and
receiving between the AP and the stations.
20/40 – the router will use 20Mhz or 40Mhz for data
transmission and receiving according to the station capability.
Such channel can increase the performance for data transit.
Guard Interval
It is to assure the safety of propagation delays and reflections for
the sensitive digital data. If you choose auto as guard interval,
the AP router will choose short guard interval (increasing the