Installation guide

Vigor3200 Series Quick Start Guide
4
1
1
.
.
2
2
.
.
2
2
F
F
o
o
r
r
V
V
i
i
g
g
o
o
r
r
3
3
2
2
0
0
0
0
n
n
LED Status Explanation
Blinking The router is powered on and running normally. ACT (Activity)
Off The router is powered off.
On USB device is connected and ready for use. USB
Blinking The data is transmitting.
On Wireless access point is ready.
Blinking Ethernet packets are transmitting over wireless
LAN.
WLAN
Off The WLAN function is inactive.
VPN On The VPN tunnel is active.
On The WAN1 ~ WAN4 connection is ready. WAN1-4
Blinking It will blink while transmitting data.
CSM On The profile(s) of CSM (Content Security
Management) for IM/P2P, URL/Web Content Filter
application can be enabled from Firewall
>>General Setup. (Such profile must be
established under CSM menu).
On The port is connected.
Off The port is disconnected.
Left LED
(Green)
Blinking The data is transmitting.
On The port is connected with 1000Mbps.
WAN 1/2/3/4
Right LED
(Green)
Off The port is disconnected with 100Mbps.
On The port is connected.
Off The port is disconnected.
Left LED
(Green)
Blinking
The data is transmitting.
On
The port is connected with 100Mbps.
DMZ
Right LED
(Green)
Off
The port is connected with 10Mbps.
On The port is connected.
Off The port is disconnected.
Left LED
(Green)
Blinking The data is transmitting.
On The port is connected with 1000Mbps.
LAN
Right LED
(Green)
Off The port is disconnected with 100Mbps.