Operation Manual

Vigor2926 Series User’s Guide
889
1 - enable
-h [enable] Enable/disable call hold mode based on protocol RFC2543 (0:
disable, 1:enable).
-i [enable] Enable CODEC change without Re-INVITE.
0 - disable
1 - enable
-p [enable] Enable PRACK message.
0 – Not support PRACK.
1 – Support PRACK.
-P [enable] Enable IP Call.
0 – Disable IP call.
1 – Enable IP call.
-H [enable] SIP INFO packet will be sent out when encounting hook flash event.
0 - disable
1 - enable
-t [val] Set the mode of User-Agent (e.g., phone, software, and device) for
SIP packet.
0 - Hide SIP header "User-Agent".
1 - Show SIP header "User-Agent".
2 - Use default "User-Agent" value.
3 - Use user-defined "User-Agent" value.
-u UAValue For every SIP user agent identifies itself with a string, this command
allows you to set the value (e.g, IP address, phone number, e-mail
address) of User-Agent. The length of the string must be less than
64 characters.
-D [disable] Disable VoIP Service.
1 – disable VoIP service.
0 – enable VoIP service.
System will automatic reboot to activate voip service
-v View current status for miscellaneous settings.
voip sip nat - Allows users to set NAT Traversal Setting.
-s [server] Set the IP address for STUN server.
-t [sec] Set ping interval for SIP account.
Sec – 6 ~ 600
-i [ip] Indicate external IP address.
-v View current settings for SIP NAT.
E
E
x
x
a
a
m
m
p
p
l
l
e
e
> voip sip misc -t 1
includes User-Agent header
> voip sip misc -u 91704688carrie
user-defined User-Agent:91704688carrie
> voip sip acc 1 -P carrie_1 -r 1 -d 172.16.3.133
> voip sip acc 1 -t 30
> voip sip misc -h 1
> voip sip acc 1 -v
index : 1
profile : carrie_1