Operation Manual

Vigor2926 Series User’s Guide
883
ch Set the FAX error correction mode.
ch : range (0 ~ 1)
mode mode : EC(error correction) ch(x) mode(0) : REDUNDANCY
EC(error correction) ch(x) mode(1) : FEC
voip dsp setDtmfCidlevel –l / voip dsp setDtmfCidlevel –h [value]
voip dsp setDtmfCidlevel –r 0
value “setDtmfCidLevel” is used to configure the signal strength for
transferring to FXS DTMF caller ID.
value - 0 ~ 64
voip dsp setDtmfCidLevel -l [value]
voip dsp setDtmfCidLevel -h [value]
voip dsp setDtmfCidLevel -r 0/1
r - reset low/high DTNF level to default setting. 0 means Disable; 1
means Enable.
Note: This function is supported only by special mode.
voip dsp setfxoCY
value It is used to apply FXO country settings.
0: "use system country"
1: "Taiwan"
2: "Germany"
3: "Sweden"
4: "France"
5: "Switzerland"
6: "Holland"
7: "Finland"
8: "Denmark"
9: "UK"
10: "Australia"
12: "Italy"
14: "Red_China"
15: "Singapore"
17: "Spain"
18: "Portugal"
20: "Poland"
21: "Czech"
22: "Hungary"
23: "Slovenia"
25: "Slovakia"
37: "Brasil"
61: "US"
voip dsp setfxoringl
value It is used to configure detection ring voltage threshold to apply to
FXO.
Available setting include:
0 : use driver default value
1 : Minimum voltage threshold: 25V
2 : Minimum voltage threshold: 35V
3 : Minimum voltage threshold: 45V
Note: This function is supported only by special mode.
voip dsp setfxoCid
value Set FXO detect caller ID type.
It is available only for the model with FXO port.
voip dsp cidplusdigit
[1/0] [channel] [value] Set the substitution (0~9) for '+' digit in caller ID.
1 – enable the substitution.