Operation Manual

Vigor2926 Series User’s Guide
779
[<command>
<parameter>|…]
The available commands with parameters are listed below.
[…] means that you can type in several commands in one
line.
-m [value] It means to set ICMP, UDP or TCP as flowtest mode.
Value – 1, 2 or 3. In which,
1: ICMP
2: UDP
3: TCP
-d [value] It means to set the original direction
Value – 1 or 2. In which,
1: LAN to WAN
2: WAN to LAN
-v [value] It means to choose IP version.
Value – 4 or 6. In which,
4: IPv4
6: IPv6
-i [value] It means to specify IPv4 address of LAN device (e.g.,
192.168.1.10).
-j [value] It means to specify IPv4 address of WAN divice (e.g.,
8.8.8.8).
-l [value] It means to specify IPv6 address of LAN device (e.g.,
2001:5678:0000:0000:1319:8a2e:0370:7343).
-w [value] It means to specify IPv6 address of WAN divice (e.g.,
2001:1234:0000:0000:1319:8a2e:0370:7344).
-p [value] It means to set port number of LAN device (e.g., 65535)
-q [value] It means to set port number of WAN device (e.g., 53).
-e [value] It means to set MAC address of LAN device (e.g.,
AA:BB:CC:11:22:33).
set
[index] Index: 1 to 5.
-e [value] It means to enable /disable the test packet.
Value – 1 or 0. In which,
1: enable
0: disable
-w [value] It means to set direction of this packet.
Value – 1 or 2. In which,
1: LAN to WAN
2: WAN to LAN
-y [value] It means to set the payload type of this packet.
Value – 1 to 7. In which,
1: Customize
2: Echo Request
3: Echo Reply
4: Destination Unreachable
5: Ping Request
6: Pin Reply