Operation Manual

Vigor2926 Series User’s Guide
761
n=7:6rd
[<command>
<parameter>|…]
The available commands with parameters are listed below.
[…] means that you can type in several commands in one line.
-m n It means to set IPv6 MTU.
N = any value (0 means “unspecified”).
-u <username> It means to set Username.
<username>= type a name as the username (maximum 63
characters).
-p <password> It means to set Password.
<password> = type a password (maximum 63 characters).
-s <server> It means to set Tunnel Server IP.
<server>= IPv4 address or URL (maximum 63 characters).
-d <server> It means to set the primary DNS Server IP.
<server>= type an IPv6 address for first DNS server.
-D <server> It means to set the secondary DNS Server IP.
<server>= type an IPv6 address for second DNS server.
-t <dhcp/ra/none> It means to set IPv6 PPP WAN test mode for DHCP or RADVD.
<dhcp/ra/none>= type IPv6 address.
-V It means to view IPv6 Internet Access Profile.
-o It means to set AICCU always on.
1=On,
0=Off
E
E
x
x
a
a
m
m
p
p
l
l
e
e
> ip6 internet -W 2 -M 2 -u 88886666 -p draytek123456 –s
amsterdam.freenet6.net
This setting will take effect after rebooting.
Please use "sys reboot" command to reboot the router.
> system reboot