Operation Manual

Vigor2926 Series User’s Guide
9
4
Enable Channel 5/6/7 Check it to enable this channel.
WAN Type Specify a WAN type of the PVC Channel/VLAN.
General Settings VLAN Tag – Type the value as the VLAN ID number. Valid
settings are in the range from 1 to 4095. The network traffic
flowing on each channel will be identified by the system via
their VLAN Tags. Channels using the same WAN type may not
configure the same VLAN tag value.
Priority – Choose the number to determine the packet
priority for such VLAN. The range is from 0 to 7.
Service Tag Value – Such value varies depending on the
setting configured in WAN>>General Setup. If required,
click Modify to open WAN>>General Setup. Then, enable
VLAN Tag insertion for service (outer tag) and specify the
value as the VLAN ID number. Or, disable it.
Open Port-based Bridge
Connection for this
Channel
The settings here will create a bridge between the LAN ports
selected and the WAN. The WAN interface of the bridge
connection will be built upon the WAN type selected using
the VLAN tag configured.
Physical Members – Group the physical ports by checking the
corresponding check box(es) for applying the port-based
bridge connection.
Note: LAN port P1 is reserved for NAT use and cannot be
selected for bridging.
Open WAN Interface for
this Channel
Check the box to enable relating function.
WAN Application - Management can be specified for general
management (Web configuration/telnet/TR069). If you
choose Management, the configuration for this VLAN will be
effective for Web configuration/telnet/TR069.
IPTV - The IPTV configuration will allow the WAN interface to
send IGMP packets to IPTV servers.
WAN Setup – Choose PPPoE/PPPoA or Static or Dynamic IP
to determine what WAN settings must be configured.
ISP Access Setup Enter your allocated username, password and authentication
parameters according to the information provided by your
ISP.
ISP Name – PPP Service Name. Enter if your ISP requires this
setting; otherwise leave blank.
Username – Name provided by the ISP for PPPoE/PPPoA
authentication. Maximum length is 62 characters.
Password – Password provided by the ISP for PPPoE/PPPoA
authentication. Maximum length is 62 characters.
PPP Authentication –The protocol used for PPP