Operation Manual

Vigor2926 Series User’s Guide
401
Source IP /
Destination IP
To set the IP address manually, please choose Any
Address/Single Address/Range Address/Subnet Address as
the Address Type and type them in this dialog.
Protocol Specify the protocol(s) which this filter rule will apply to.
Source Port /
Destination Port
(=) – when the first and last value are the same, it indicates
one port; when the first and last values are different, it
indicates a range for the port and available for this service
type.
(!=) – when the first and last value are the same, it
indicates all the ports except the port defined here; when
the first and last values are different, it indicates that all
the ports except the range defined here are available for
this service type.
(>) – the port number greater than this value is available.
(<) – the port number less than this value is available for
this profile.
3. Click Next to get the following page.
Available settings are explained as follows:
Item Description
Pass Immediately Packets matching the rule will be passed immediately.
APP Enforcement - Select an APP Enforcement profile for
global IM/P2P application blocking. If there is no profile for
you to select, please choose [Create New] from the drop
down list in this page to create a new profile. All the hosts
in LAN must follow the standard configured in the APP
Enforcement profile selected here. For detailed
information, refer to the section of APP Enforcement
profile setup. For troubleshooting needs, you can specify to
record information for IM/P2P by checking the Log box. It
will be sent to Syslog server. Please refer to section
Syslog/Mail Alert for more detailed information.