Operation Manual

Vigor2926 Series User’s Guide
170
Available settings are explained as follows:
Item Description
Enable Check to enable RADIUS client feature.
Server IP Address/Hostname - Enter the IP address of
RADIUS server.
Destination Port - The UDP port number that the RADIUS
server is using. The default value is 1812, based on RFC 2138.
Shared Secret - The RADIUS server and client share a secret
that is used to authenticate the messages sent between
them. Both sides must be configured to use the same shared
secret. The maximum length of the shared secret you can set
is 36 characters.
Confirm Shared Secret - Re-type the Shared Secret for
confirmation.
Enable Accounting After checking it, Vigor router supports the accounting
feature (available seconds for using, quantity of RX/TX data)
for external RADIUS server. Any client tries to access the
Internet shall be authenticated and accounted by an external
RADIUS server.
Accounting Port –The UDP port number that the RADIUS
server is using. The default value is 1813, based on RFC 2138.
Disconnect Message Port – Set a port number for listenning
the RADIUS disconnection message.
Update Interval – Set a time interval for sending the
accounting request to the RADIUS server.
RADIUS Server Status Log Display the record of current status of RADIUS server.
After finished the above settings, click OK button to save the settings.