Operation Manual

Vigor2926 Series User’s Guide
10
7
F
F
a
a
i
i
l
l
o
o
v
v
e
e
r
r
When configured in Failover mode, the WAN interface will only be active when the primary
WAN disconnects, and will be down again when the primary WAN resume its service.
To configure a WAN interface in Failover mode, go to WAN >> General Setup, click on the
index which you would like to configure to Failover Mode, set Active Mode to "Failover", and
for Active When, choose the conditions about when should this interface be activated.
Info Router determines if a WAN is disconnected or not according to "WAN
Connection Detection" settings in WAN >> Internet Access.