Operation Manual

Vigor2832 Series User’s Guide
58
automatically among all of the WAN interfaces in
connection status.
Active When If you choose Failover as the Active Mode, the option of
Active When will appear.
 Any of the selected WAN disconnect – Such WAN
connection will be activated when any selected WAN
interface (checked below) disconnects.
 All of the selected WAN disconnect – Such WAN
connection will be activated only when all of selected
WAN interfaces (checked below) disconnect.
 Check boxes for WAN1 to WAN4 – Specify the WAN
interface by checking the WAN box.
After finished the above settings, click OK to save the settings.
I
I
I
I
-
-
1
1
-
-
1
1
-
-
3
3
W
W
A
A
N
N
3
3
/
/
W
W
A
A
N
N
4
4
(
(
U
U
S
S
B
B
)
)
To use 3G/4G network connection through 3G/4G USB Modem, please configure WAN3 or
WAN4 interface.
Available settings are explained as follows:
Item Description
Enable Choose Yes to invoke the settings for this WAN interface.
Choose No to disable the settings for this WAN interface.
Display Name Type the description for such WAN interface.
Physical Mode Display the physical mode of such WAN interface.
Line Speed If your choose According to Line Speed as the Load Balance
Mode, please type the line speed for downloading and
uploading for such WAN interface. The unit is kbps.
Active Mode Choose Always On to make such WAN connection being
activated always.
Load Balance: Check this box to enable auto load balance
function for such WAN interface.
When the data traffic is large, the WAN interface with the
function enabled will balance the data transmission
automatically among all of the WAN interfaces in connection