Operation Manual

Vigor2832 Series User’s Guide
578
Status: Connected
>
T
T
e
e
l
l
n
n
e
e
t
t
C
C
o
o
m
m
m
m
a
a
n
n
d
d
:
:
i
i
p
p
6
6
r
r
a
a
d
d
v
v
d
d
This command allows you to enable or disable RADVD server.
S
S
y
y
n
n
t
t
a
a
x
x
Ip6 radvd [LAN1|LAN2|...|LAN4] [-<command> <parameter>| ... ]
ip6 radvd [R|u]
S
S
y
y
n
n
t
t
a
a
x
x
D
D
e
e
s
s
c
c
r
r
i
i
p
p
t
t
i
i
o
o
n
n
Parameter Description
LAN1|LAN2|...|LAN4 It means to specify LAN interface for such address.
<command> <parameter>
-s It means to enable or disable the default lifetime of the RADVD
server.
1: Enable the RADVD server.
0: Disable the RADVD server.
-D <1/0> Enable/Disable the RDNSS.
-d <lifetime> Set the default lifetime for RADVD server.
-i <lifetime> Set the mininum interval time(sec) for RADVD server.
-I <lifetime> Set the maximum interval time(sec) for RADVD server.
Lifetime It means to set the lifetime.
The lifetime associated with the default router in units of seconds.
It’s used to control the lifetime of the prefix. The maximum value
corresponds to 18.2 hours. A lifetime of 0 indicates that the router
is not a default router and should not appear on the default router
list.
Type the number (unit: second) you want.
-h <hoplimit> Set hop limit for RADVD server.
-m <mtu/auto> Set MTU value for RADVD server.
Range: 1280-1500.
auto - auto select MTU from WAN.
-e <time> Set reachable time.
-a <time/infinity> Set retransmit timer /infinity.
-p <0/1/2> Set default preference Low/Medium/High for RADVD server.
-v View the RADVD server configuration.
-V It means to show the RADVD configuration.
-L <time/infinity>: Set prefix valid lifetime.
-P <time/infinity> Set prefix preferred lifetime.
-r [num] Make RADVD test for item [num].
num - 0-default, 121:logo 121, 124:logo 124.
-R Reload Config and send RA for subnets.
-u View MTU on all interfaces.
E
E
x
x
a
a
m
m
p
p
l
l
e
e