Operation Manual

Vigor2832 Series User’s Guide
15
7
Clear All- Click to remove all of the user profiles in Available
List.
Available List – The user profiles without RADIUS server
enabled in User Management >> User Profile will be listed
in this field.
Authentication List –The user profiles with RADIUS server
enabled in User Management >> User Profile will be listed
in this field.
Synchronize Internal
RADIUS user list to Local
802.1X user list
Users can be authenticated by RADIUS server and local
802.1X to get certain network service. It is not necessary to
create new user profiles (containing user accounts and user
passwords) for RADIUS and local 802.1X respectively.
Simply check this box; all of the user profiles (prepared for
RADIUS server authentication) listed in Authentication List
will be synchronized for local 802.1X user authentication.
After finished the above settings, click OK button to save the settings.
I
I
I
I
-
-
4
4
-
-
5
5
-
-
3
3
E
E
x
x
t
t
e
e
r
r
n
n
a
a
l
l
T
T
A
A
C
C
A
A
C
C
S
S
+
+
It means Terminal Access Controller Access-Control System Plus. It works like RADIUS does.
Click the TACACS+ Setup to open the following page:
Available settings are explained as follows:
Item Description
Enable Check to enable TACACS+ feature.
Server IP Address Enter the IP address of TACACS+ server.
Destination Port The UDP port number that the TACACS+ server is using.
Shared Secret The TACACS+ server and client share a secret that is used to
authenticate the messages sent between them. Both sides
must be configured to use the same shared secret.
Confirm Shared Secret Re-type the Shared Secret for confirmation.
After finished the above settings, click OK button to save the settings.