Operation Manual

Vigor2832 Series User’s Guide
3
I
I
-
-
1
1
-
-
1
1
I
I
n
n
d
d
i
i
c
c
a
a
t
t
o
o
r
r
s
s
a
a
n
n
d
d
C
C
o
o
n
n
n
n
e
e
c
c
t
t
o
o
r
r
s
s
f
f
o
o
r
r
V
V
i
i
g
g
o
o
r
r
2
2
8
8
3
3
2
2
a
a
n
n
d
d
V
V
i
i
g
g
o
o
r
r
2
2
8
8
3
3
2
2
n
n
Before you use the Vigor router, please get acquainted with the LED indicators and
connectors first.
LED Status Explanation
Blinking The router is powered on and running normally. ACT (Activity)
Off The router is powered off.
On A USB device is connected and active. USB1~USB2 /
USB
Blinking The data is transmitting.
On Wireless access point is ready.
Blinking Ethernet packets are transmitting over wireless LAN.
WLAN
Off The WLAN function is inactive.
On The WAN connection is ready. WAN2
Blinking It will blink while transmitting data.
On The router is ready to access Internet through DSL link.
DSL
Blinking Slowly: The DSL connection is ready.
Quickly: The connection is training.
On The VPN tunnel is active.
Off VPN services are disabled
VPN
Blinking Traffic is passing through VPN tunnel.
QoS On The QoS function is active.
WCF On The Web Content Filter is active. (It is enabled from
Firewall >> General Setup).
On The DoS/DDoS function is active. DoS
Blinking It will blink while detecting an attack.
LED on Connector
On The port is connected.
Off The port is disconnected.
Left
LED
Blinking The data is transmitting.
On The port is connected with 1000Mbps.
LAN
Right
LED
Off The port is connected with 10/100Mbps
On The port is connected.
Off The port is disconnected.
Left
LED
Blinking The data is transmitting.
On The port is connected with 1000Mbps.
WAN2
Right
LED
Off The port is connected with 10/100Mbps