Operation Manual

Vigor2832 Series User’s Guide
135
PC to select one.
Choose IP Click this button and then a window will automatically pop
up, as depicted below. The window consists of a list of private
IP addresses of all hosts in your LAN network. Select one
private IP address in the list to be the DMZ host.
When you have selected one private IP from the above dialog,
the IP address will be shown on the screen. Click OK to save
the setting.
DMZ Host for WAN2, WAN3, or WAN4 is slightly different with WAN1.
See the following figure.
If you previously have set up WAN Alias for PPPoE or Static or Dynamic IP mode in WAN2
interface, you will find them in Aux. WAN IP for your selection.
Available settings are explained as follows:
Item Description
Enable Check to enable the DMZ Host function.
Private IP Enter the private IP address of the DMZ host, or click Choose
PC to select one.