Operation Manual

Vigor2832 Series User’s Guide
92
two options.
VLAN Tag – Type the value as the VLAN ID number. Valid
settings are in the range from 1 to 4095. The network traffic
flowing on each channel will be identified by the system via
their VLAN Tags. Channels using the same WAN type may not
configure the same VLAN tag value.
Priority – Choose the number to determine the packet
priority for such VLAN. The range is from 0 to 7.
ATM OoS Such function is available only when ADSL is selected as WAN
Type.
QoS Type - Select a proper QoS type for the channel.
Type the values for PCR, SCR and MBS respectively.
Open Port-based Bridge
Connection for this
Channel
The settings here will create a bridge between the LAN ports
selected and the WAN. The WAN interface of the bridge
connection will be built upon the WAN type selected using
the VLAN tag configured.
Physical Members – Group the physical ports by checking the
corresponding check box(es) for applying the port-based
bridge connection.
Open WAN Interface for
this Channel
Check the box to enable relating function.
WAN Application –
 Management – It can be specified for general
management (Web configuration/telnet/TR069). If you
choose Management, the configuration for this VLAN
will be effective for Web configuration/telnet/TR069.
 IPTV - The IPTV configuration will allow the WAN
interface to send IGMP packets to IPTV servers.
WAN Connection
Detection
Such function is available only when ADSL is selected as WAN
Type.
It allows you to verify whether network connection is alive or
not through ARP Detect or Ping Detect.
Mode – Choose ARP Detect or Ping Detect for the system to
execute for WAN detection. If you choose Ping Detect as the
detection mode, you have to type required settings for the
following items.
 Primary/Secondary Ping IP – If you choose Ping Detect as
detection mode, you have to type Primary or Secondary IP
address in this field for pinging.
 Ping Gateway IP – If you choose Ping Detect as detection
mode, you also can enable this setting to use current WAN
gateway IP address for pinging.
With the IP address(es) pinging, Vigor router can check if
the WAN connection is on or off.
 TTL (Time to Live) – Set TTL value of PING operation.
 Ping Interval – Type the interval for the system to
execute the PING operation.
 Ping Retry – Type the number of times that the system is
allowed to execute the PING operation before WAN
disconnection is judged.
WAN Setup Choose PPPoE/PPPoA or MPoA as the protocol in General
Settings for such channel.
 If PPPoE/PPPoA Client is selected, you have to configure
the settings listed under ISP Access Setup. Enter your
allocated username, password and authentication