Operation Manual

Vigor2760 Series User’s Guide
576
off
It means to disable IPSec ESP tunnel passthrough and IKE
source port (500) preservation.
status
It means to display current status for checking.
E
E
x
x
a
a
m
m
p
p
l
l
e
e
> srv nat ipsecpass status
%% Status: IPsec ESP pass-
t
hru and IKE src_port:500 preservation is
OFF.
Telnet Command: srv nat openport
This command allows users to set open port settings for NAT server.
srv nat openport n m [-<command> <parameter> | … ]
S
S
y
y
n
n
t
t
a
a
x
x
D
D
e
e
s
s
c
c
r
r
i
i
p
p
t
t
i
i
o
o
n
n
Parameter Description
n
It means the index number for the profiles. The range is from
1 to 20.
m
It means to specify the sub-item number for this profile. The
range is from 1 to 10.
[<command>
<parameter>|…]
The available commands with parameters are listed below.
[…] means that you can type in several commands in one
line.
-a <enable>
It means to enable or disable the open port rule profile.
0: disable
1:enable
-c <comment>
It means to type the description (less than 23 characters) for
the defined network service.
-i <local ip>
It means to set the IP address for local computer.
Local ip: Type an IP address in this field.
-w <idx>
It means to specify the public IP.
1: WAN1 Default,
2: WAN1 Alias 1,
…and so on.
-p <protocol>
Specify the transport layer protocol.
Available values are TCP, UDP and ALL.
-s<start port>
It means to specify the starting port number of the service
offered by the local host. The range is from 0 to 65535.
-e<end port>
It means to specify the ending port number of the service
offered by the local host.
The range is from 0 to 65535.
-v
It means to display current settings.