Operation Manual

Vigor2760 Series User’s Guide
196
receives the first packet for test. Different way means the
firewall will process the connection initiated from LAN or
from WAN.
Test View
This is a dynamic display page.
According to the direction specified, test view will display
the figure to guide you typing IP address, port number, and
MAC address.
Later, after clicking the Analyze button, the information for
the firewall rule profile and address translation will be
shown on this page.
Src IP
Type the IPv4/IPv6 address of the packet’s source.
Src MAC
Type the MAC address of the packet’s source.
Dst IP
Type the IPv4/IPv6 address of the packet’s destination.
Packet & Payload
In firewall diagnose, two packets belong to one connection.
In general, two packets are enough for Vigor router to
perform this test.
Enable – Check the box to send out the test packet.
Direction – The first packet of the firewall test will follow
the direction specified above. However, the direction for the
second packet might be different. Simply choose the
direction (from Computer A to B or from the B to A) for the
second packet.
Protocol – It displays the mode selected above and the sate.
If required, click the mode link to configure advanced
setting. The common service type (Customize, Ping, Trace
Route / Customize, DNS, Trace Route / Customize,
Http(GET) related to that mode (ICMP / UDP / TCP) will
be shown on the following dialog box.
 Type – Choose Customize, Ping, Trace Route /
Customize, DNS, Trace Route / Customize, Http
(GET).
 Payload – It is available when Customzie is selected.
Simply type 16 HEX characters which represent
certain packet (e.g., DNS packet) if you want to set the
data transfered with protocol (ICMP/UDP/TCP)
which is different to Type setting.
Analyze
Execute the test and analyze the result.