Operation Manual

Vigor2760 Series User’s Guide
123
 MPoA: Multiprotocol over ATM.
Encapsulation - (Available when WAN Type is ADSL)
Encapsulation mode used for the ASDL connection.
Contact your ISP or carrier for the appropriate setting.
 VC MUX: Virtual Circuit Multiplexing.
 LLC/SNAP: Logical Link Control/Subnetwork Access
Protocol.
Add VLAN Header – (Available when WAN type is
ADSL) If selected, enable VLAN tagging on this PVC.
 VLAN Tag – Type the value as the VLAN ID
number. Valid settings are in the range from 1 to
4095. The network traffic flowing on each channel
will be identified by the system via their VLAN Tags.
Channels using the same WAN type may not
configure the same VLAN tag value.
 Priority – Choose the number to determine the packet
priority for such VLAN. The range is from 0 to 7.
ATM OoS
Configures the Quality of Service (QoS) of the ATM
circuit.
QoS Type - Select a proper QoS type for the channel.
Type the values for PCR (Peak Cell Rate), SCR
(Sustainable Cell Rate) and MBS (Maximum Burt Size)
respectively.
Bridge mode
If selected, bridge this channel to one or more LAN ports.
Physical Members– Group the physical ports by checking
the corresponding check box(es) for applying the bridge
connection.
Note: LAN port P1 is reserved for NAT use and cannot be
selected for bridging.
After finished the above settings, click OK to save the settings.
A
A
d
d
v
v
a
a
n
n
c
c
e
e
d
d
Such configuration is applied to upstream packets. Such information will be provided by ISP.
Please contact with your ISP for detailed information.
Note that such web page is available only when ADSL is selected as WAN type.