Operation Manual

Vigor2760 Series User’s Guide
120
this Channel WAN Application –
 Management – It can be specified for general
management (Web configuration/telnet/TR069). If
you choose Management, the configuration for this
VLAN will be effective for Web
configuration/telnet/TR069.
 IPTV - The IPTV configuration will allow the WAN
interface to send IGMP packets to IPTV servers.
 VoIP - The VoIP configuration will allow the WAN
interface to send VoIP packets to servers.
WAN Connection
Detection
It is available when Open WAN Interface for this
Channel is enabled.
It allows you to verify whether network connection is alive
or not through ARP Detect or Ping Detect.
Mode – Choose ARP Detect or Ping Detect for the system
to execute for WAN detection. If you choose Ping Detect as
the detection mode, you have to type required settings for
the following items.
 ARP Detect - The router broadcasts an ARP request
every 5 seconds. If no response is received within 30
seconds, the WAN connection is deemed to have failed.
 Ping Detect - The router sends an ICMP (Internet
Control Message Protocol) echo request every second to
the host, whose address is specified in the Ping IP field,
to verify the WAN connection. If the remote host does
not respond within 30 seconds, the WAN connection is
deemed to have failed.
 Primary/Secondary Ping IP – If you choose
Ping Detect as detection mode, you have to type
Primary or Secondary IP address in this field for
pinging.
 Ping Gateway IP – If you choose Ping Detect
as detection mode, you also can enable this
setting to use current WAN gateway IP address
for pinging.
With the IP address(es) pinging, Vigor router
can check if the WAN connection is on or off.
 TTL – Time To Live, the maximum allowed
number of hops to the ping destination. Valid
values range from 1 to 255.
 Ping Interval – Type the interval for the system
to execute the PING operation.
 Ping Retry – Type the number of times that the
system is allowed to execute the PING operation
before WAN disconnection is judged.
PPPoE/PPPoA Client ISP
Access Setup
Enter your allocated username, password and authentication
parameters according to the information provided by your
ISP.
ISP Name – PPP Service Name. Enter if your ISP requires
this setting; otherwise leave blank.
Username – Name provided by the ISP for PPPoE/PPPoA