Operation Manual

Vigor2760 Series User’s Guide
119
available. The user will be able to select the physical WAN
interface the channel shall use here.
ADSL- A PVC Channel will be created using an ADSL
connection on WAN1.
VDSL- A VLAN will be created using a VDSL connection
on WAN1.
Ethernet (WAN2) - A VLAN will be created on WAN2.
General Settings
VPI - (Available when WAN Type is ADSL) Virtual Path
Identifier. Contact your ISP or carrier for the appropriate
value.
VCI - (Available when WAN Type is ADSL) Virtual
Channel Identifier. Contact your ISP or carrier for the
appropriate value.
Protocol - (Available when WAN Type is ADSL) Access
protocol used for the ADSL connection. Contact your ISP
or carrier for the appropriate setting.
 PPPoA: Point-to-Point over ATM.
 PPPoE: Point-to-Point over Ethernet.
 MPoA: Multiprotocol over ATM.
Encapsulation - (Available when WAN Type is ADSL)
Encapsulation mode used for the ASDL connection.
Contact your ISP or carrier for the appropriate setting.
 VC MUX: Virtual Circuit Multiplexing.
 LLC/SNAP: Logical Link Control/Subnetwork Access
Protocol.
Add VLAN Header – (Available when WAN type is
ADSL) If selected, enable VLAN tagging on this PVC.
 VLAN Tag – Type the value as the VLAN ID
number. Valid settings are in the range from 1 to
4095. The network traffic flowing on each channel
will be identified by the system via their VLAN Tags.
Channels using the same WAN type may not
configure the same VLAN tag value.
 Priority – Choose the number to determine the packet
priority for such VLAN. The range is from 0 to 7.
Open Port-based Bridge
Connection for this
Channel
The settings here will create a bridge between the LAN
ports selected and the WAN. The WAN interface of the
bridge connection will be built upon the WAN type selected
using the VLAN tag configured.
Physical Members – Group the physical ports by checking
the corresponding check box(es) for applying the port-based
bridge connection.
Open WAN Interface for
Check the box to enable relating function.