Network Router User Manual
Table Of Contents
- Table of Contents
- 1. Preface
- 2. Configuring Basic Settings
- 3. User Mode Operation
- 4. Admin Mode Operation
- 5. Application and Examples
- 6. Trouble Shooting
- 6.1 Checking If the Hardware Status Is OK or Not
- 6.2 Checking If the Network Connection Settings on Your
- 6.3 Pinging the Router from Your Computer
- 6.4 Checking If the ISP Settings are OK or Not
- 6.5 Forcing Vigor Router into TFTP Mode for Performing the
- 6.6 Backing to Factory Default Setting If Neces
- 6.7 Contacting Your Dealer
Vigor2750 Series User’s Guide
43
When DHCP is selected as connection type, you need to configure the following settings:
Router Name
Type the name of the router.
Domain Name
Type the domain name obtained from the ISP.
When PPPoE is selected as connection type, you need to configure the following settings:
Username
Type the name obtained from the ISP.
Password
Type the password obtained from the ISP.
Confirm Password
Type the password again for confirmation.
MTU Size
Type th
e largest size (in bytes) of a packet.
After finishing all the settings here, please click OK to activate them.
3
3
.
.
2
2
.
.
3
3
3
3
G
G
B
B
a
a
c
c
k
k
u
u
p
p
This page is used to setup 3G backup function. If you enable 3G backup, make sure your
WAN connection type is not in 3G mode. When the WAN connection is broken, router will
try to keep the connection with 3G mode. After WAN connection is recovered, router will
disconnect the 3G connection automatically.